Displays

Supported display types

• Passive display (e.g. LCD/OLED screen)

• Interactive displays (e.g. multitouch whiteboards)

• Video wall (with multitouch frame)

• Passive projector

• Interactive projector (e.g. with touch pen)

• Dual projectors with edge blending

Supported Resolutions

• Full HD, 16:9 aspect ratio (1920 x 1080 pixels)

• 4K, 16:9 aspect ratio (3840 x 2160 pixels)

• 5K, 21:9 aspect ratio (5120 x 2160 pixels)

Recommended settings

• On interactive displays, for a smooth writing experience, set the refresh rate of your video card to 60 Hz or higher (please note that generally only one video input port can support this setting. If in doubt, check the hardware manual).

• Use HDMI 2.0+ cables

Consumer Electronics Control (CEC)

Configure the settings of your Front of Room displays to support Consumer Electronics Control (CEC) or enable PC mode. If you want the room display to automatically switch to Mago when it wakes up from standby mode, certain conditions must be met. This feature is optional but supported by the Mago software, as long as the underlying hardware supports the feature. A consumer TV used as a display in the living room must support the Consumer Electronics Control (CEC) feature of HDMI. Depending on the dock or console selected (which may not support CEC, refer to the manufacturer's support documentation), a controller such as the Crestron HD-RX-4K-201-C-E, Liberty's DL-UHDILC, or the Extron HD CTL 100 may be required to enable the desired behavior.